SOLVED: Titan one not connecting

[Lopto]

He everyone
Got the Titan one
updated firmware then it was stuck in P mode.
Did the firmware recovery
then shows the AU animation. it looks more like an upside down U and U
loaded script plug into console and all i get is AU
Did the Firmware recovery again as suggested and still the same.
Also Bluetooth not syncing but i dont know if it is the same problem.
Any ideas or suggestions appreciated.

[Lopto]

Ok i see that it is not AU
it looks like half circles alternating.

[J2Kbr]

Hello the up-and-down animation is normal, it goes away when the device detects the console and the controller.

For test the device please first use a regular controller. With everything working follow the instructions below to connect you wiimote on the Titan One.

http://www.consoletuner.com/kbase/wiimo ... nsions.htm

[OFC-Giorgio]

Hi Lopto,

Did you follow the steps at: viewtopic.php?f=14&t=468 ?

Greetings,
Gio

[ofc-hazard]

Hi Lopto. My first two dongles weren't compatible. Provided info on the one that works in wiimote loses connection thread. It was pretty cheap on newegg.

[Lopto]

Hello the up-and-down animation is normal, it goes away when the device detects the console and the controller.

For test the device please first use a regular controller. With everything working follow the instructions below to connect you wiimote on the Titan One.

http://www.consoletuner.com/kbase/wiimo ... nsions.htm

Problem solved. Thanks to all.
Still need to se up a more permanent sensor bar.

[ofc-hazard]

Hi Lopto - I tried soldering a sensor bar onto a power supply like Giorgio did, but I had problems because the sensor bar wires are very small. I ended up buying an official WiiU battery-powered sensor bar at Best Buy for $20. It has more IR bulbs than the knock-offs and works very well. I would suggest using rechargeable AAs if you have them.

[Lopto]

That's what I'm using now.
I find it odd that I can sync to PS3
Then turn on WiiU and the wiimote won't
See the sensor bar.