Anti-Recoil Abnormal Move XIM APEX and Titan Two
38 posts
• Page 1 of 4 • 1, 2, 3, 4
Anti-Recoil Abnormal Move XIM APEX and Titan Two
I use RAINBOWsixSIEGE MODzPACK v1.06 Bonfisher and The Division v1.20 Scachi.
After Titan Two firmware 0.98B-36 was updated, each normal full firing recoils will sometimes go up, sometimes go down or sometimes not much go up or down. I tested each firing (Left triggering, then firing) in shooting range room.
Before Titan Two was updated, anti-recoils in rainbow six and division were tuned at almost perfect condition.
After Titan Two firmware 0.98B-36 was updated, each normal full firing recoils will sometimes go up, sometimes go down or sometimes not much go up or down. I tested each firing (Left triggering, then firing) in shooting range room.
Before Titan Two was updated, anti-recoils in rainbow six and division were tuned at almost perfect condition.
Last edited by Farmer on Sun Mar 18, 2018 1:12 am, edited 3 times in total.
-
Farmer - Staff Sergeant
- Posts: 11
- Joined: Fri Mar 16, 2018 9:07 am
Re: Anti-Recoil Abnormal Move XIM APEX and Titan Two
I just updated 0.98B-38 and set 1000Hz output polling rate.
I use Xim Apex at 1000Hz and My mouse is Logitech G600 at 1000Hz
Abnormal move still exists.
I use Xim Apex at 1000Hz and My mouse is Logitech G600 at 1000Hz
Abnormal move still exists.
-
Farmer - Staff Sergeant
- Posts: 11
- Joined: Fri Mar 16, 2018 9:07 am
Re: Anti-Recoil Abnormal Move XIM APEX and Titan Two
Antithesis in XIM forum gives me some suggestions.
http://community.xim.tech/index.php?topic=63030.0
The problem is what and wherre the antithese anti-recoil script copy and paste into other script.
http://community.xim.tech/index.php?topic=63030.0
The problem is what and wherre the antithese anti-recoil script copy and paste into other script.
-
Farmer - Staff Sergeant
- Posts: 11
- Joined: Fri Mar 16, 2018 9:07 am
Re: Anti-Recoil Abnormal Move XIM APEX and Titan Two
Welcome to our community Farmer.
The recent updates didn't receive any change that could change that.
Please note in general the anti-recoil of scripts and Gamepack are focused on gamepads (stick). For mouse (XIM) based anti-recoil please check this post:
viewtopic.php?f=20&t=6917
The recent updates didn't receive any change that could change that.
Please note in general the anti-recoil of scripts and Gamepack are focused on gamepads (stick). For mouse (XIM) based anti-recoil please check this post:
viewtopic.php?f=20&t=6917
ConsoleTuner Support Team
-
J2Kbr - General of the Army
- Posts: 20323
- Joined: Tue Mar 18, 2014 1:39 pm
Re: Anti-Recoil Abnormal Move XIM APEX and Titan Two
If your playing rb6 you could try changing dead zone in game options menu to see if that helps.
- bonefisher
- Lieutenant General
- Posts: 5413
- Joined: Thu Jan 29, 2015 10:49 am
Re: Anti-Recoil Abnormal Move XIM APEX and Titan Two
bonefisher wrote:If your playing rb6 you could try changing dead zone in game options menu to see if that helps.
I tried 5 or 10 right deadzone in game setting. Abnormal anti-recoil move still exists. Randomly move one direction.
-
Farmer - Staff Sergeant
- Posts: 11
- Joined: Fri Mar 16, 2018 9:07 am
Re: Anti-Recoil Abnormal Move XIM APEX and Titan Two
I found important issue. Antithesis anti-recoil script is a static anti-recoil. Thanks for Scachi, make static anti-recoil to dynamic anti-recoil in Division GPC script. The script helps anti-recoil controllable when normal full firing to a target. Yes you can melt enemy head in few seconds. But sometimes abnormal anti-recoil moving may occur but not much.
-
Farmer - Staff Sergeant
- Posts: 11
- Joined: Fri Mar 16, 2018 9:07 am
Re: Anti-Recoil Abnormal Move XIM APEX and Titan Two
No anti-recoil is dynamic, it's all static.
Scachi's has a number of stages where you can adjust the anti-recoil value to correspond with steps in The Division's recoil patterns, depending on how long you've been shooting e.g < 1000ms = 30, 1000 > 3000ms = 40, > 3000ms = 60. Just mess around with the numbers, depending on the weapon you're using, keeping in mind that adjusting one will cascade to the others.
Honestly, The Division's recoil is a horrible mess. If you want a clean, smooth shooting experience, get an SMG and pair it with a shield. It's buttery-smooth compared to everything else in the game.
Alternately, how I handle recoil for Assault Rifles is by burst-firing. If you get the timing right, you can empty a clip pretty quickly, but without the recoil.
Scachi's has a number of stages where you can adjust the anti-recoil value to correspond with steps in The Division's recoil patterns, depending on how long you've been shooting e.g < 1000ms = 30, 1000 > 3000ms = 40, > 3000ms = 60. Just mess around with the numbers, depending on the weapon you're using, keeping in mind that adjusting one will cascade to the others.
Honestly, The Division's recoil is a horrible mess. If you want a clean, smooth shooting experience, get an SMG and pair it with a shield. It's buttery-smooth compared to everything else in the game.
Alternately, how I handle recoil for Assault Rifles is by burst-firing. If you get the timing right, you can empty a clip pretty quickly, but without the recoil.
-
antithesis - Colonel
- Posts: 1912
- Joined: Sat May 28, 2016 10:45 pm
Re: Anti-Recoil Abnormal Move XIM APEX and Titan Two
antithesis wrote:No anti-recoil is dynamic, it's all static.
Scachi's has a number of stages where you can adjust the anti-recoil value to correspond with steps in The Division's recoil patterns, depending on how long you've been shooting e.g < 1000ms = 30, 1000 > 3000ms = 40, > 3000ms = 60. Just mess around with the numbers, depending on the weapon you're using, keeping in mind that adjusting one will cascade to the others.
Honestly, The Division's recoil is a horrible mess. If you want a clean, smooth shooting experience, get an SMG and pair it with a shield. It's buttery-smooth compared to everything else in the game.
Alternately, how I handle recoil for Assault Rifles is by burst-firing. If you get the timing right, you can empty a clip pretty quickly, but without the recoil.
I test Scachi adjusted Division script and give Scachi opinion "I found one important issue. When normal full firing and the mouse or controller right stick is moving, the anti-recoil value randomly and continuously change. Sometimes change to very low anti-recoil value and aim down sight is moving up fast. I use higher slide bar value (from 30 to 80) to reduce the possibility of low anti-recoil value. Aim down sight is controllable with moving mouse or controller stick unless low anti-recoil value occurs."
-
Farmer - Staff Sergeant
- Posts: 11
- Joined: Fri Mar 16, 2018 9:07 am
Re: Anti-Recoil Abnormal Move XIM APEX and Titan Two
I have been having the same issues in Battlefield 4... My recoil changes also came after update. My recoil rates are way out of whack compared to my previous rates ones... I was spot on with a recoil rate of 28.5 and now my settings are in the mid 40s... My gun swings hard because of these settings and it kills my game... I have noticed it in all the gamepacks that I have tried... I'm am playing on Xbox one...
-
glenf - Staff Sergeant
- Posts: 11
- Joined: Tue Oct 31, 2017 8:18 pm
- Location: Iowa
38 posts
• Page 1 of 4 • 1, 2, 3, 4
Who is online
Users browsing this forum: No registered users and 152 guests