Page 3 of 3

Re: T2 not working -- Xim Apex (with Xim Link) and T2

PostPosted: Sat Oct 05, 2019 8:34 pm
by 2fast4u
@Scachi: See attached.

Re: T2 not working -- Xim Apex (with Xim Link) and T2

PostPosted: Sat Oct 05, 2019 8:37 pm
by 2fast4u
DontAtMe wrote:Connect the Titan Two to your PC.
This time both PROG and OUTPUT, need to be connected to your PC. At the same time.

Open GtunerIV, and change the output to USB Xbox 360.
When this is done, take a screenshot of the device monitor.

then look at the Output led on the front of the t2, check to see if it is on.
if its not, disconnect the output cable, and then take the cable that's plugged into PROG, and connect it to OUTPUT instead.
And see if the output led turns on.


See attached. Output light is green with this setup.

Re: T2 not working -- Xim Apex (with Xim Link) and T2

PostPosted: Sat Oct 05, 2019 10:56 pm
by bonefisher
Thought you needed a SD Card for HID to work with the download files?

Re: T2 not working -- Xim Apex (with Xim Link) and T2

PostPosted: Sun Oct 06, 2019 3:04 am
by Scachi
2fast4u wrote:@Scachi: See attached.

I have no idea why it is showing "HID [OUT]" for "USB-C". I think it should show "Xbox One [Out]" instead when the Output port was correctly connected to your xbox one console in this case.
I would try this setup again (xbox controller,xbox console,pc-prog) and try different cables for the output connection to the xbox console to test if it will change "USB-C" to read "Xbox one [Out]" in GTuner IV Device Monitor then.

Re: T2 not working -- Xim Apex (with Xim Link) and T2

PostPosted: Sun Oct 06, 2019 10:06 pm
by 2fast4u
Fixed it!!! Thanks for all your help.

For some reason, it turns out the usb cable that came with the titan two was the culprit. I tried different usb's to and from controllers, etc. However, I never tried swapping out the T2 usb cable that was connecting the T2 to the xbox controller. After swapping out that cable it all worked.

Re: T2 not working -- Xim Apex (with Xim Link) and T2 (solve

PostPosted: Sun Oct 06, 2019 11:38 pm
by bonefisher
Glad to hear that it is working! :smile0517: