XIM4 and T2 and PS4 PRO best DEVICE CONFIG SETTINGS?
Moderator: antithesis
4 posts
• Page 1 of 1
XIM4 and T2 and PS4 PRO best DEVICE CONFIG SETTINGS?
Just wanted to know the best device config settings. Not sure what to put for these:
Output polling rate?
Input Polling rate?
Force USB prog interface to full speed?
BTW i have a Version 1 controller and im on sa3 firmware
Output polling rate?
Input Polling rate?
Force USB prog interface to full speed?
BTW i have a Version 1 controller and im on sa3 firmware
-
SweatyPapi - Sergeant Major
- Posts: 91
- Joined: Fri Feb 08, 2019 12:52 am
Re: XIM4 and T2 and PS4 PRO best DEVICE CONFIG SETTINGS?
Output polling rate 1000hz
Input polling rate doesn't matter, that's only if a mouse is connected directly to the T2
Leave Force USB prog interface to full speed unchecked.
Input polling rate doesn't matter, that's only if a mouse is connected directly to the T2
Leave Force USB prog interface to full speed unchecked.
ConsoleTuner Support Team || ConsoleTuner Discord || InputSense Discord
- Mad
- Major General
- Posts: 4536
- Joined: Wed May 22, 2019 5:39 am
Re: XIM4 and T2 and PS4 PRO best DEVICE CONFIG SETTINGS?
Given you're using a XIM4, I'd go with 125Hz for both Input and Output to match the XIM's speed, especially when using SA3 which uses quantization to further dampen output.
If you find AA is still too sticky on the XIM, try 1000Hz T2 Output Polling.
Full USB speed means dropping the T2 from 480 Mbps USB 2.0 high speed down to 12 Mbps full speed. I don't see a good reason to do it, but test it for yourself.
If you find AA is still too sticky on the XIM, try 1000Hz T2 Output Polling.
Full USB speed means dropping the T2 from 480 Mbps USB 2.0 high speed down to 12 Mbps full speed. I don't see a good reason to do it, but test it for yourself.
-
antithesis - Colonel
- Posts: 1912
- Joined: Sat May 28, 2016 10:45 pm
Re: XIM4 and T2 and PS4 PRO best DEVICE CONFIG SETTINGS?
antithesis wrote:Given you're using a XIM4, I'd go with 125Hz for both Input and Output to match the XIM's speed, especially when using SA3 which uses quantization to further dampen output.
If you find AA is still too sticky on the XIM, try 1000Hz T2 Output Polling.
Full USB speed means dropping the T2 from 480 Mbps USB 2.0 high speed down to 12 Mbps full speed. I don't see a good reason to do it, but test it for yourself.
Antithesis and Mad are GOATS let me tell you!
-
SweatyPapi - Sergeant Major
- Posts: 91
- Joined: Fri Feb 08, 2019 12:52 am
4 posts
• Page 1 of 1
Return to XIM Apex, XIM4, XIM Edge with Titan devices
Who is online
Users browsing this forum: No registered users and 122 guests