Xim Apex on Switch (using Titan2)
Moderator: antithesis
3 posts
• Page 1 of 1
Xim Apex on Switch (using Titan2)
Is it possible to use my xim on the nintendo switch with my Titan 2? If so could someone possibly give me some tips on how this works? I have tried to do it once and was not able to figure it out but I am not very saavy with either. I've reached out about this before and no one replied :( Thanks!
-
PHooLy - Private First Class
- Posts: 3
- Joined: Wed Jan 13, 2021 12:22 pm
Re: Xim Apex on Switch (using Titan2)
So, if I plug my xbox one controller into Input A and change output protocol to nintendo swith, the controller works. If I unplug the controller and plug in the xim plugged into input A with controller/keyboard/mouse plugged into xim as it usually is then plug it back into input A, the controller will blink a few times then turn off. That's the issue I am having with the switch. When I do this same setup on PC or Xbox, it works fine. Any suggestions?
-
PHooLy - Private First Class
- Posts: 3
- Joined: Wed Jan 13, 2021 12:22 pm
Re: Xim Apex on Switch (using Titan2)
You should be able to, a quick search shows that others have done it.
Try connecting the controller last, so plug in the xim/t2 into the switch and then finally the controller.
Try with / without batteries in.
Or try removing one of the devices, either keyboard or mouse and see if it works with one less connected in case it is a power issue.
Try connecting the controller last, so plug in the xim/t2 into the switch and then finally the controller.
Try with / without batteries in.
Or try removing one of the devices, either keyboard or mouse and see if it works with one less connected in case it is a power issue.
ConsoleTuner Support Team || ConsoleTuner Discord || InputSense Discord
- Mad
- Major General
- Posts: 4536
- Joined: Wed May 22, 2019 5:39 am
3 posts
• Page 1 of 1
Return to XIM Apex, XIM4, XIM Edge with Titan devices
Who is online
Users browsing this forum: No registered users and 24 guests