Xbox 360
Moderator: antithesis
5 posts
• Page 1 of 1
Xbox 360
by nytemare01 » Sat May 12, 2018 11:28 pm
Getting disconnected when using the apex/t2 on the 360. Both set to 500hz polling.
-
nytemare01 - First Sergeant
- Posts: 42
- Joined: Fri Jan 26, 2018 7:35 am
Re: Xbox 360
by antithesis » Sun May 13, 2018 2:34 am
Apex doesn't support more than 125Hz on last-gen consoless. Disconnects though likely have more to do with a faulty USB cable or insufficient power.
-
antithesis - Colonel
- Posts: 1912
- Joined: Sat May 28, 2016 10:45 pm
Re: Xbox 360
by alQaisar » Mon May 28, 2018 2:36 am
antithesis wrote:Apex doesn't support more than 125Hz on last-gen consoless. Disconnects though likely have more to do with a faulty USB cable or insufficient power.
if T2 polls at 1000Hz and is the one connected to the last-gen console will this setup work
mouse report at 1000Hz ==> xim apex poll at 1000Hz then report to T2 at 1000Hz ==>T2 poll from xim at 1000Hz than report to console at 1000Hz ==> last-gen console poll from T2 at 1000Hz .
-
alQaisar - Private First Class
- Posts: 2
- Joined: Thu Aug 24, 2017 7:11 am
Re: Xbox 360
by J2Kbr » Tue May 29, 2018 11:46 am
alQaisar wrote:antithesis wrote:Apex doesn't support more than 125Hz on last-gen consoless. Disconnects though likely have more to do with a faulty USB cable or insufficient power.
if T2 polls at 1000Hz and is the one connected to the last-gen console will this setup work
mouse report at 1000Hz ==> xim apex poll at 1000Hz then report to T2 at 1000Hz ==>T2 poll from xim at 1000Hz than report to console at 1000Hz ==> last-gen console poll from T2 at 1000Hz .
yes, this works. Just remember to configure the Titan Two output polling rate to 1000HZ.
ConsoleTuner Support Team
-
J2Kbr - General of the Army
- Posts: 20323
- Joined: Tue Mar 18, 2014 1:39 pm
5 posts
• Page 1 of 1
Return to XIM Apex, XIM4, XIM Edge with Titan devices
Who is online
Users browsing this forum: No registered users and 48 guests