The Division Script rev2
32 posts
• Page 3 of 4 • 1, 2, 3, 4
Re: The Division Script rev2
Update* Version 1.0.8:
+ added preset data script/slot control/communication to be able to load a different preset in-game
You need to download from the Online Resource
the main script: "The Division rev2"
and the data script: "The Division rev2 Data"
and put them on different slots on your T2.
Configure the main scripts option "[Weapon-Data T2 Slot]" (last one in Interactive Configuration) to point to the Slot containing the data script".
Run the main script as usual.
If you want to load a different preset for you active profile hold L2+R3 for > 4 seconds.
That will switch to the data scripts slot.
Use DPAD-Up / Down to cycle through the presets, the name gets displayed via the segment display on the T2.
To write this preset to the active weaponslot hold Cross button > 500ms. The LED will blink for a short time to indicate writing.
To change the weapon use the Triangle button to be able to load a preset for a different weapon slot.
To return to the main slot hold Circle button -> 500ms
+ added preset data script/slot control/communication to be able to load a different preset in-game
You need to download from the Online Resource
the main script: "The Division rev2"
and the data script: "The Division rev2 Data"
and put them on different slots on your T2.
Configure the main scripts option "[Weapon-Data T2 Slot]" (last one in Interactive Configuration) to point to the Slot containing the data script".
Run the main script as usual.
If you want to load a different preset for you active profile hold L2+R3 for > 4 seconds.
That will switch to the data scripts slot.
Use DPAD-Up / Down to cycle through the presets, the name gets displayed via the segment display on the T2.
To write this preset to the active weaponslot hold Cross button > 500ms. The LED will blink for a short time to indicate writing.
To change the weapon use the Triangle button to be able to load a preset for a different weapon slot.
To return to the main slot hold Circle button -> 500ms
-
Scachi - Brigadier General
- Posts: 3044
- Joined: Wed May 11, 2016 6:25 am
- Location: Germany
Re: The Division Script rev2
Update 1.0.9:
+ changed battery warning level to 12% as ps4 controller reports in 11% steps
+ changed battery warning level to 12% as ps4 controller reports in 11% steps
-
Scachi - Brigadier General
- Posts: 3044
- Joined: Wed May 11, 2016 6:25 am
- Location: Germany
Re: The Division Script rev2
Update Version 1.10:
+ fixed bug that could change anti recoil values by accident / without being in adjustment mode
+ fixed bug that could change anti recoil values by accident / without being in adjustment mode
-
Scachi - Brigadier General
- Posts: 3044
- Joined: Wed May 11, 2016 6:25 am
- Location: Germany
Re: The Division Script rev2
Update Version 1.11:
+ added Autoscope/DeadEye mode to scope automatically and disable antirecoil for active deadeye stability ability
(release L2 to a value below 95% for that)
On/off configurable per Profile and Weaponslot (primary/secondary) ingame toggle: L2+DPAD_Right
+ added Autoscope/DeadEye mode to scope automatically and disable antirecoil for active deadeye stability ability
(release L2 to a value below 95% for that)
On/off configurable per Profile and Weaponslot (primary/secondary) ingame toggle: L2+DPAD_Right
-
Scachi - Brigadier General
- Posts: 3044
- Joined: Wed May 11, 2016 6:25 am
- Location: Germany
Re: The Division Script rev2
Update Version 1.12
+ deadeye/scope settings are now read correct from IC settings and are also written back on change.
+ deadeye/scope settings are now read correct from IC settings and are also written back on change.
-
Scachi - Brigadier General
- Posts: 3044
- Joined: Wed May 11, 2016 6:25 am
- Location: Germany
Re: The Division Script rev2
Wow, this is a completely unique approach compared to your other script. Is it safe to assume that the script will work fine on XB1, just have to make sure the correct sequence of buttons are used? Also, is there any way to possibly REM out (I know old school...lol) the option for sprint (auto climb) I know the old script was left stick down while holding L2(LT - XB1) It never failed to be sprinting and have an immediate need for L2, and this would enable auto climb by mistake; which caused an odd turning motion in game.
Thanks for continuing to improve this script.
Thanks for continuing to improve this script.
-
3TEWS - Staff Sergeant
- Posts: 14
- Joined: Fri Feb 23, 2018 5:45 pm
Re: The Division Script rev2
3TEWS wrote:Wow, this is a completely unique approach compared to your other script. Is it safe to assume that the script will work fine on XB1, just have to make sure the correct sequence of buttons are used? Also, is there any way to possibly REM out (I know old school...lol) the option for sprint (auto climb) I know the old script was left stick down while holding L2(LT - XB1) It never failed to be sprinting and have an immediate need for L2, and this would enable auto climb by mistake; which caused an odd turning motion in game.
Thanks for continuing to improve this script.
The script should work fine for xb1.
I don't understand what sprint has to do with auto climb and don't think that my previous script was doing anything on L2+left stick down. Both scripts don't have auto run/sprint. My previous one doesn't have auto-climb.
You can disable auto climb in the Interactive Configuration.
-
Scachi - Brigadier General
- Posts: 3044
- Joined: Wed May 11, 2016 6:25 am
- Location: Germany
Re: The Division Script rev2
You are completely correct, somehow I have screwed up trying to learn and modify it. I completely wiped it out and started over...the new one is great, love the configuration menu. GREAT JOB!
-
3TEWS - Staff Sergeant
- Posts: 14
- Joined: Fri Feb 23, 2018 5:45 pm
Re: The Division Script rev2
moderation: quote removed
Hi
How to enable Auto Run ?
Kindest Regards
S13
S13
- S13002931
- First Sergeant
- Posts: 55
- Joined: Fri Jun 16, 2017 12:47 pm
Re: The Division Script rev2
Whats the point of quoting all the text for a single question ? Auto Run isn't listed as a feature as this script has NO Auto Run.
-
Scachi - Brigadier General
- Posts: 3044
- Joined: Wed May 11, 2016 6:25 am
- Location: Germany
32 posts
• Page 3 of 4 • 1, 2, 3, 4
Return to User's Script Documentation
Who is online
Users browsing this forum: No registered users and 60 guests