Ok, I thought it might be me but there's something else going on.
If I click the gear for the interactive configuration and edit Standing Anti Recoil Settings, I can insert a "-", delete the number and insert a negative number or click the arrows until they reach the desired negative number.
However, there's a different behavior if I click a weapon in One Touch Config (I was very excited about this!) and _then_ try to put in a negative value: I can't do it.
I tried to use the One Touch Config and I wasn't sure if config is sent to the Titan and saved (it does appear to do that.) I tried using just the One Touch Config button and using it followed by the Save and Run button and it seems to get the same results.
After closing the Interactive Config window (click OK) and opening back up, I can then edit the updated value and make it negative by putting "-" in to the left of the value.
You might consider adding an explicit checkbox for "I am using Inverted Vertical Look" or at least making a note with One Touch Config to explain the work around during your next update.
Otherwise, I think the One Touch Config is a HUGE TIMESAVER for this script and the script overall is great! Thanks!
One more quick question: I'm not sure I'm using the 'easy walk/sprint' correctly. Do I enable it and then to use it, left stick forward and down (PS4 L3) to enable? Or is it supposed to sprint automatically? Or is it supposed to sprint at left stick full-forward? Or...