Page 8 of 12

Re: Battlefield Five by Bonefisher Megathread

PostPosted: Sat Apr 13, 2019 9:39 pm
by bonefisher
Check the weapons rpm rate then adjust to that to see if it clears... If it is a automatic then you shouldn't have rapid fire on!

Re: Battlefield Five by Bonefisher Megathread

PostPosted: Sun Apr 14, 2019 6:31 am
by jelly44
bonefisher wrote:Check the weapons rpm rate then adjust to that to see if it clears... If it is a automatic then you shouldn't have rapid fire on!


thanks, it may be that then!

Re: Battlefield Five by Bonefisher Megathread

PostPosted: Tue Apr 16, 2019 8:00 pm
by Carlope
bonefisher wrote:You must not be doing the one click config right::::: Hit the copy then go in on the item line with weapon stating: then number311313313 highlight just number then paste new number in.. Go back where number begins and take out GIVICFG: and you should be good then load back and slot one click and save and run to see if changes are done!

Hi did exactly that, i also disabled autorun and when pasted the numbers over saved and reloaded it all was the same.

Re: Battlefield Five by Bonefisher Megathread

PostPosted: Tue Apr 16, 2019 8:49 pm
by bonefisher
Carlope wrote:
bonefisher wrote:You must not be doing the one click config right::::: Hit the copy then go in on the item line with weapon stating: then number311313313 highlight just number then paste new number in.. Go back where number begins and take out GIVICFG: and you should be good then load back and slot one click and save and run to see if changes are done!

Hi did exactly that, i also disabled autorun and when pasted the numbers over saved and reloaded it all was the same.

Add a item and your setting to see if that works!

Re: Battlefield Five by Bonefisher Megathread

PostPosted: Tue Apr 16, 2019 8:56 pm
by Carlope
Carlope wrote:
bonefisher wrote:You must not be doing the one click config right::::: Hit the copy then go in on the item line with weapon stating: then number311313313 highlight just number then paste new number in.. Go back where number begins and take out GIVICFG: and you should be good then load back and slot one click and save and run to see if changes are done!

Hi did exactly that, i also disabled autorun and when pasted the numbers over saved and reloaded it all was the same.

ok so the only way i can make my tweaks save and work if i post the code into notepad and copy and paste it from there. Replacing the code in the script does not work for me, just goes back to the default.

Just to let you know that all guns are way off when it comes to recoil, would be nice if it was updated i guess.

Re: Battlefield Five by Bonefisher Megathread

PostPosted: Tue Apr 16, 2019 9:06 pm
by Carlope
i dragged and dropped your script then downloaded it and it opened in edit mode in g tuner. i then clicked to configure setting of the script, changed the value on anti recoil and copied the code which included GIVICFG: i took that part out and only replaced numbers with existing item. i then ran the compiler and saved. opened to configure the settings clicked on the item i changed the value and it just loads default.

I think i did it right, didnt i ?

Re: Battlefield Five by Bonefisher Megathread

PostPosted: Tue Apr 16, 2019 11:51 pm
by bonefisher
You have to drag it to slot after compiling then open interactive configuration>>>one click the new item you put in then save and run!

Re: Battlefield Five by Bonefisher Megathread

PostPosted: Wed Apr 17, 2019 9:56 pm
by Carlope
That worked thanks a mill.

Re: Battlefield Five by Bonefisher Megathread

PostPosted: Thu Apr 18, 2019 12:10 am
by bonefisher
:smile0517:

Re: Battlefield Five by Bonefisher Megathread

PostPosted: Thu Apr 18, 2019 2:37 pm
by J2Kbr
@jelly44, the Gtuner IV released this morning fixes the reported issue. Thank you for bringing this to my attention.