T2 not working(flashes A U) Switch
5 posts
• Page 1 of 1
T2 not working(flashes A U) Switch
So I turned on my pc today and was getting ready to do some scripting. However, the T2 cannot see my controller. I have 2 controllers connected to my Nintendo Switch. The first is a PDP Faceoff and the second is a pro controller. It can't see either of them in the device monitor on my pc. Also, pressing buttons does nothing and I have to plug directly into the Switch to even get past the first screen. My computer has been updating and restarting several times recently so that might have something to do with it. Any ideas let me know.
-
Endless - Master Sergeant
- Posts: 38
- Joined: Thu May 02, 2019 1:06 am
Re: T2 not working(flashes A U) Switch
Did you do the first time config on the switch ?
If you have "turn off with the console" enabled (Titan Two - Device Configuration), please try disable this option to check if it solves the issue.After a recent Switch update this setting is not working properly with the Nintendo Switch.
This guide seems to be missing that you have to connect your controller to the T2 Input-A or Input-B then.
First-time Configuration
On Nintendo Switch, enable wired communication:
System Settings → Controllers and Sensors → Check the Option: Pro Controller Wired Communication.
Configure the Output Protocol of the Titan Two to USB Automatic or USB Nintendo Switch
If you have "turn off with the console" enabled (Titan Two - Device Configuration), please try disable this option to check if it solves the issue.After a recent Switch update this setting is not working properly with the Nintendo Switch.
Regular Usage:
Connect the provided Micro-USB cable to the Titan Two USB port labeled OUTPUT;
Connect the other end of the Micro-USB cable to any available USB port on the Nintendo Switch Dock Station.
This guide seems to be missing that you have to connect your controller to the T2 Input-A or Input-B then.
-
Scachi - Brigadier General
- Posts: 3044
- Joined: Wed May 11, 2016 6:25 am
- Location: Germany
Re: T2 not working(flashes A U) Switch
I can't use the Device Configuration because it doesn't detect the T2. I uploaded a screenshot so you can see.
- Attachments
-
- no device.jpg (242.65 KiB) Viewed 548 times
-
Endless - Master Sergeant
- Posts: 38
- Joined: Thu May 02, 2019 1:06 am
Re: T2 not working(flashes A U) Switch
Did you plug your T2 into your PC with the right port? It should be the PROG port.
-
Buffy - Lieutenant
- Posts: 422
- Joined: Wed Jul 20, 2016 5:23 am
Re: T2 not working(flashes A U) Switch
Thanks, Buffy. I had the ports backward for PROG and OUTPUT. It shows up on my computer now.
-
Endless - Master Sergeant
- Posts: 38
- Joined: Thu May 02, 2019 1:06 am
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 90 guests