Titan Two keeps disconnecting from GTuner

[Liquidkhaos]

My device keeps disconnecting from GTuner. It is remains detected, however, the disconnect does not seem to be on any schedule eg every x seconds or every time I do y. :( And I can always select it from the dropdown to reconnect it as soon as its disconnected. This occurs in as little as 3 second to as long as about a minute and is quite duplicatable.

Is there a solution for this? Is it normal?

Current Setup:

No external power supply.
No bluetooth adaptor.
T2 connected to PC USB Dualshock 4 connected to T2 Input A.
Prog light on T2 remains on regardless of GTuners reported connection status.
I have tried connected using the 'full speed mode' (holding the down arrow when connecting) does not affect the behaviour.





Capture.PNG (3.4 KiB) Viewed 2566 times

[antithesis]

Try a different USB cable connecting the T2 to your PC.

[Liquidkhaos]

OK. Trying this now.

I am currently using the 12" one that came with the T2.

EDIT: Behavior remains the same. Tried 3 cables. 1 must have been a charging cable only as the device was not detected at all while plugged on for that one. The other cables had the same behavior as the one that came from with the T2. Tried with and without the controller connected.

[Scachi]

Are you using a sd-card ? If yes, try it without it, using just the 3 slots on the Titan Two itself.

[Liquidkhaos]

No SD card yet. I figured I don't know anything yet so 3 slots should be plenty. lol

Thanks for the response.

[Scachi]

Do you have access to another computer to try it there ? Just for ruling out the problems with the computers usb ports.
On my computer the T2 sometimes disconnects because of my front-usb ports being used out, where other hardware seems to be working better (no disconnects), on the usb-ports at the back of my pc it works fine, maybe the T2/GTuner is a bit picky and requires a more stable connection than other stuff.

[J2Kbr]

maybe the T2/GTuner is a bit picky and requires a more stable connection than other stuff.

On these lines, he also can enable the option "Force USB PROG Interface to full speed (12Mbps", this should make the connection more stable under certain circumstances.

[Liquidkhaos]

I will test another USB slot. And I will try the full speed interface again.

[Droid1977]

same issue except mine changes the prog light from green to orange. I have tried formatting the mmc card, I have tried without the card, on 5 cables, 2 laptops and 1 PC. Always the same.. never stays connected to Gtuner for more than 5 minutes while sometimes will not stay connected for more than 10 seconds. I have also tried wiping all gpc code from it and starting new, no different results. frustrating.

[Droid1977]

Bump
*** any help welcomed, any suggestion is appreciated*****

as a side note I do not even have to disconnect the T2, I just have to go to the drop down bar in the top right of GTunner and select it again and it will connect right away... super frustrating.