Titan Two keeps disconnecting from GTuner

[J2Kbr]

Please enable the option "Force USB PROG Interface to full speed (12Mbps)" on the "Device Configurations" panel for check if this provides a more stable connection with PC.

[Jalal]

Please enable the option "Force USB PROG Interface to full speed (12Mbps)" on the "Device Configurations" panel for check if this provides a more stable connection with PC.

can you please show me how to do that, can you please take a picture of where is "device Configuration"

[J2Kbr]

Definitively, please note the red arrow.

DeviceConfiguration.png (17.17 KiB) Viewed 1425 times

[Liquidkhaos]

I was never able to resolve. I also tried "Force USB PROG Interface to full speed"

[Sillyasskid]

I was never able to resolve. I also tried "Force USB PROG Interface to full speed"

I believe you are having disconnects because of the scripts you may be using.

You have to implement better flow control inside your scripts.
Using this script of yours
viewtopic.php?f=26&t=7423&p=54963#p54963
will cause frequent disconnects, so I assume when you said you got the script to work, you meant you just got the script to compile only?

When I was debugging this script of yours, I got frequent disconnect as expected..... I just wanted wanted to confirm, and check the CPU level.
The CPU almost reaches 2.00% That's very high.

[Liquidkhaos]

FWIW: I get the same behaviour regarding disconnects with no script in the device and no scripts loaded in GTuner. :( My disconnects are quick though between 3 and 18 seconds. Its usually a race to drag and drop on a meme slot.

[Sillyasskid]

Gtuner does not actually run the script, it only compiles the code. The script gets transferred over to your titan two when you hit run. Also the script wont unload when it gets disconnected. If the device it connected to an output, it will remain active until you unload the script manually

[J2Kbr]

@Liquidkhaos, have you tried in another computer? if not, please try. this can help in troubleshooting this problem. thanks.

[Jalal]

Definitively, please note the red arrow.

DeviceConfiguration.png

your're the man. Thank you sir. mine now works perfectly

[Liquidkhaos]

@Liquidkhaos, have you tried in another computer? if not, please try. this can help in troubleshooting this problem. thanks.

When I get a new one. This is an Alienware m18X with 4G i7 & dual SLI graphics cards running Windows 10. I have turned off all power saver features on USB & network devices. I have tried with an AC powered hub as well.

If you have any other ideas I would love to try them out.