ConsoleTuner

Iv just ordered the new nacon unlimited pro controller and im wondering if it's possible to pair it to the titan two without the Bluetooth dongle that comes with the controller,? Thnx in advance

In general support for Bluetooth connection with controllers requires to by manually added to the Titan Two firmware, just adding the VID:PID is not enough. However, recently we managed to get a controller to work successfully by just doing that and it may worth try with the Nacon.

Thnx for ur reply, i will try later and if it doesnt work i will jjst use the dongle,

I am looking to buy one too. Is there any online shop that can ship worldwide? Thanks!

Dimakra666 wrote:Iv just ordered the new nacon unlimited pro controller and im wondering if it's possible to pair it to the titan two without the Bluetooth dongle that comes with the controller,? Thnx in advance

Not sure i bought it from denmark

J2Kbr wrote:In general support for Bluetooth connection with controllers requires to by manually added to the Titan Two firmware, just adding the VID:PID is not enough. However, recently we managed to get a controller to work successfully by just doing that and it may worth try with the Nacon.

Can u help me plz i got it to work with the dongle but it stops after like 10 min i can switch between slots but not other things works so i have the disconnect the t2 from ps4 and reconnect it again, and if there is any instructions to how to connect it to the bluetooth module in the t2 instead of the dongle, i would apreciate all help. Thnx in advance

Can u help me plz i got it to work with the dongle but it stops after like 10 min i can switch between slots but not other things works so i have the disconnect the t2 from ps4 and reconnect it again, and if there is any instructions to how to connect it to the bluetooth module in the t2 instead of the dongle, i would apreciate all help. Thnx in advance

You need to have a genuine PS4 controller attached to Titan Two at the same time. Plug your Nacon into INPUT-A and the DS4 into INPUT-B.

Also ensure that PS4 > Settings > Devices > Controllers > Communication Method is set to USB to prevent the 10 min timeout.

Will that removes the weired stick? Cuz my t2 shows E then U even if i use cable

First, update your Gtuner IV and Titan Two firmware with the new versions released this morning.

After that proceed as the following:

1) Unplug all controllers from the Titan Two;
2) Connect the output to the PS4 console;
3) Connect the Prog port to your computer;
4) Open Gtuner IV and go to top menu Tools -> "Fetch Descriptors ...";
5) Plug the Nacon Dongle to any port at the front of the Titan Two;
6) Wait couple seconds for this window be update with the captured data;
7) Click on the button "Copy Descriptors" and post here.

Thank you.