Start Script/macro from PC
5 posts
• Page 1 of 1
Start Script/macro from PC
Hello,
Is there a way to run/"fire off" a macro I have created from the PC that programmed it, NOT via Gtuner. Via a command line, or even a keystroke from the PC plugged into the PROG port?
if yes, if you could tell me the best practice I would appreciate it !
Thanks!
Is there a way to run/"fire off" a macro I have created from the PC that programmed it, NOT via Gtuner. Via a command line, or even a keystroke from the PC plugged into the PROG port?
if yes, if you could tell me the best practice I would appreciate it !
Thanks!
-
Nerf_0 - Corporal
- Posts: 4
- Joined: Mon Dec 02, 2019 11:48 pm
Re: Start Script/macro from PC
Yes, You can do this.
Example;
Plug the T2 into the console via output and to the PC via prog.
Gtuner>File>New>New Input Translator
A --> BUTTON_1
Save the input translator when done, install to a memory slot.
Create your program or something like a AHK script to send the A key and it will output BUTTON_1 to the console.
Make sure KMG Capture is running in Gtuner; F4 or Tools>KMG Capture and select the keyboard.
Example;
Plug the T2 into the console via output and to the PC via prog.
Gtuner>File>New>New Input Translator
A --> BUTTON_1
Save the input translator when done, install to a memory slot.
Create your program or something like a AHK script to send the A key and it will output BUTTON_1 to the console.
Make sure KMG Capture is running in Gtuner; F4 or Tools>KMG Capture and select the keyboard.
ConsoleTuner Support Team || ConsoleTuner Discord || InputSense Discord
- Mad
- Major General
- Posts: 4536
- Joined: Wed May 22, 2019 5:39 am
Re: Start Script/macro from PC
can I have the input translator, and still have the GPC loaded?
Maybe there is a step I am missing. Not sure the best way to have both the "keyboard C button = button 2" and "button 2 = run this script" function at the same time.
Thanks.
Maybe there is a step I am missing. Not sure the best way to have both the "keyboard C button = button 2" and "button 2 = run this script" function at the same time.
Thanks.
-
Nerf_0 - Corporal
- Posts: 4
- Joined: Mon Dec 02, 2019 11:48 pm
Re: Start Script/macro from PC
OK i was able use the line if (key_status(KEY_F1)) to get what i needed.
Is there anyway to run KMG capture outside of gtuner?
if not, no worries. thank you very much for the help!
Is there anyway to run KMG capture outside of gtuner?
if not, no worries. thank you very much for the help!
-
Nerf_0 - Corporal
- Posts: 4
- Joined: Mon Dec 02, 2019 11:48 pm
Re: Start Script/macro from PC
Nerf_0 wrote:can I have the input translator, and still have the GPC loaded?.
Yes drag them both into the same memory slot.
Nerf_0 wrote:Is there anyway to run KMG capture outside of gtuner?
I don't think there is.
ConsoleTuner Support Team || ConsoleTuner Discord || InputSense Discord
- Mad
- Major General
- Posts: 4536
- Joined: Wed May 22, 2019 5:39 am
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 171 guests