I Can't Program Upgrade/Downgrade my T2 Device
7 posts
• Page 1 of 1
I Can't Program Upgrade/Downgrade my T2 Device
Just as the subject says, can someone please help me? I pray its not bricked, its brand new
-
riribibi - Command Sergeant Major
- Posts: 134
- Joined: Fri Oct 31, 2014 12:33 pm
Re: I Can't Program Upgrade/Downgrade my T2 Device
Try a factory reset:
1) Unplug the device.
2) Hold both the up and down arrows.
3) Plug PROG into the PC whilst still holding the up and down arrows.
4) Open Gtuner>Tools>Check for updates.
If you still have issues download a fresh copy of Gtuner IV: https://www.consoletuner.com/titan-two-downloads/
1) Unplug the device.
2) Hold both the up and down arrows.
3) Plug PROG into the PC whilst still holding the up and down arrows.
4) Open Gtuner>Tools>Check for updates.
If you still have issues download a fresh copy of Gtuner IV: https://www.consoletuner.com/titan-two-downloads/
ConsoleTuner Support Team || ConsoleTuner Discord || InputSense Discord (2K / FPS)
- Mad
- Major General
- Posts: 4533
- Joined: Wed May 22, 2019 5:39 am
Re: I Can't Program Upgrade/Downgrade my T2 Device
preciate the response but neither worked. just stuck on P displayed on the screen. again its brand new
-
riribibi - Command Sergeant Major
- Posts: 134
- Joined: Fri Oct 31, 2014 12:33 pm
Re: I Can't Program Upgrade/Downgrade my T2 Device
still needing help please
-
riribibi - Command Sergeant Major
- Posts: 134
- Joined: Fri Oct 31, 2014 12:33 pm
Re: I Can't Program Upgrade/Downgrade my T2 Device
Try replacing the cable
-
UK_Wildcats - Brigadier General
- Posts: 2243
- Joined: Thu Jan 08, 2015 6:53 pm
Re: I Can't Program Upgrade/Downgrade my T2 Device
Also, use a USB 2.0 port on PC when running firmware updates.
-
antithesis - Colonel
- Posts: 1912
- Joined: Sat May 28, 2016 10:45 pm
Re: I Can't Program Upgrade/Downgrade my T2 Device
tried both of the above - replaced the cable and a 2.0 port. still didn't work. any other suggestions or person i can tlak to?
-
riribibi - Command Sergeant Major
- Posts: 134
- Joined: Fri Oct 31, 2014 12:33 pm
7 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 90 guests