Re: Custom rack for the T2
Posted: Sat May 04, 2019 2:20 pm
Scachi wrote:jelly44 wrote:Hi Scachi - not only did I buy the wrong 90 USB parts but my rack wasn't properly printed. Either the red part was too big or the green part was too small. So the parts don't fit.
Would you be able to send me the measurements of the red part, for the parts where the green part would fit? So that thin tower and the squared looking base?
Thanks a lot
The lower part is 7mm, the upper vertical stabilization triangle like part is 2mm wide.
The parts are a tight fit, it depends a bit on the printer if the resulted parts will fit easily.
You should be able to cut the opening of the green part a bit easily with a sharp knife like a cutter-knife or scalpel like knife.
I will adjust the green part a bit so the next person printing it will have no problems.
What are the dimensions of your usb adapters ? Or what is wrong with them so I can add more information to the first post.
The knife help. Nothing like some brute force!
The issue with the USB parts was that I'd have to use the T2 facing backwards. It's the USB up/down thing. The plastic piece in the USB part which plugs to the T2 needs to be up (I think).