need hElp programming memory slots
3 posts
• Page 1 of 1
need hElp programming memory slots
my wireless 360 controller with receiver can't activate the memory slots when i press them on the controller? i was using a wired controller which worked fine but now on the wireless when i'm switching memory slots on the device it has a . beside the number idk
Last edited by 095 on Sun Nov 19, 2017 7:08 am, edited 1 time in total.
-
095 - Private
- Posts: 1
- Joined: Wed Nov 15, 2017 12:26 am
Re: need hElp programming memory slots
095 wrote:when i'm switching memory slots on the device it has a . beside the number idk
The dot at the bottom of the display means the controller is not detected/disconnected.
The dot appears when you plug the receiver into the Titan One or when you switch the slot with the Titan One's button?
Before the disconnection can you see the inputs in the Device Monitor?
Console tuner since my 1st controller.
Scripting, a game in the game.
Believe or dare, It's Titanic!
Scripting, a game in the game.
Believe or dare, It's Titanic!
-
Prototype - Major General
- Posts: 3250
- Joined: Sun Dec 16, 2012 1:43 pm
Re: need hElp programming memory slots
The memory slot change should work with the Xbox360 wireless controller. Please note, depending on the device configuration, the button combination is Back + Guide or LS + Guide.
ConsoleTuner Support Team
-
J2Kbr - General of the Army
- Posts: 20323
- Joined: Tue Mar 18, 2014 1:39 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: troyota64 and 14 guests