need lagacy sticks
Posted: Sat Nov 19, 2016 3:54 am
i just cant play shooters with out legcy sticks. is there to do this ? i have a few shooters like doom that dont have legacy sticks
main {
swap(9, 11);
}
J2Kbr wrote:
- Code: Select all
main {
swap(9, 11);
}
prototype wrote:J2Kbr wrote:
- Code: Select all
main {
swap(9, 11);
}
Use this code and it will swap button 9 (PS4_RX) and 11 (PS4_LX) to work as legacy control.
J2Kbr wrote:The basic steps to load a GPC script into Titan One are:
1) Copy and paste the code into a blank document in Gtuner's Compiler panel.
2) Save the script.
3) Go to the the Programmer Panel
4) Drag-and-drop the script name to any memory slot.
5) Click on the "Program Device" button
6) Follow the programming wizard until it finishes.
7) Connect the Titan One on console, launch the game and press the button on the device until the display shows the same number you programmed the script.
That's all. hope it helps.
xAUSTIN316x wrote:prototype wrote:J2Kbr wrote:
- Code: Select all
main {
swap(9, 11);
}
Use this code and it will swap button 9 (PS4_RX) and 11 (PS4_LX) to work as legacy control.
this is for xbox one controller not ps4
xAUSTIN316x wrote:J2Kbr wrote:The basic steps to load a GPC script into Titan One are:
1) Copy and paste the code into a blank document in Gtuner's Compiler panel.
2) Save the script.
3) Go to the the Programmer Panel
4) Drag-and-drop the script name to any memory slot.
5) Click on the "Program Device" button
6) Follow the programming wizard until it finishes.
7) Connect the Titan One on console, launch the game and press the button on the device until the display shows the same number you programmed the script.
That's all. hope it helps.
lol this still tells me nothing where do i go to do the swaps cause your Tutorials Section is way to complicated
bonefisher wrote:xAUSTIN316x wrote:J2Kbr wrote:The basic steps to load a GPC script into Titan One are:
1) Copy and paste the code into a blank document in Gtuner's Compiler panel.
2) Save the script.
3) Go to the the Programmer Panel
4) Drag-and-drop the script name to any memory slot.
5) Click on the "Program Device" button
6) Follow the programming wizard until it finishes.
7) Connect the Titan One on console, launch the game and press the button on the device until the display shows the same number you programmed the script.
That's all. hope it helps.
lol this still tells me nothing where do i go to do the swaps cause your Tutorials Section is way to complicated
This tells you exactly what to do. Copy and paste the code above to a new GPC script and make sure you delete everything before pasteing code then save. Then 3 thru 6 follow!