Cannot flash Titan One on Windows 10
4 posts
• Page 1 of 1
Cannot flash Titan One on Windows 10
I want to use the Titan One with a wired PS4 controller on Xbox One. In trying to update it it now tells me that it is in some recovery mode and needs the proper software. No matter what I do, when it goes to update the device disconnects and then cannot be found. Any help would be greatly appreciated.
Before this, I would get the same issue where the device is recognized but any attempt to update resulted in the device disconnecting and then a message from GTuner that the device could not be found.
-smb
Before this, I would get the same issue where the device is recognized but any attempt to update resulted in the device disconnecting and then a message from GTuner that the device could not be found.
-smb
-
nuja - Private
- Posts: 1
- Joined: Wed Dec 11, 2019 8:57 pm
Re: Cannot flash Titan One on Windows 10
You have to redo the firmware update right after the recovery update.
https://www.consoletuner.com/kbase/firm ... s=AAAAAA==
https://www.consoletuner.com/kbase/firm ... s=AAAAAA==
Console tuner since my 1st controller.
Scripting, a game in the game.
Believe or dare, It's Titanic!
Scripting, a game in the game.
Believe or dare, It's Titanic!
-
Prototype - Major General
- Posts: 3252
- Joined: Sun Dec 16, 2012 1:43 pm
Re: Cannot flash Titan One on Windows 10
Do you have access to other computer you could try the firmware recovery procedure again? Thanks.
ConsoleTuner Support Team
-
J2Kbr - General of the Army
- Posts: 20323
- Joined: Tue Mar 18, 2014 1:39 pm
Re: Cannot flash Titan One on Windows 10
Also, use a USB 2.0 port on PC to run firmware updates on Titan One.
-
antithesis - Colonel
- Posts: 1912
- Joined: Sat May 28, 2016 10:45 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 137 guests