[Gtuner Pro v.3.70] Ximput not being seen as a controller?
1 post
• Page 1 of 1
[Gtuner Pro v.3.70] Ximput not being seen as a controller?
I recently got the Titan One after I read that it's firmware was updated to recognize the Nintendo Switch and wanted to a setup similar to this (https://www.youtube.com/watch?v=uTlwVyWobRc) through Parsec. The issue I'm having though is Gtuner's "Device Monitor" isn't seeing any Ximputs whether it's through Parsec acting as a virtual controller or a even an actual wired controller plugged in.
In "Direct Input" it sees the Ximput with the plugged in controller.
I opened MaxAim DI and I'm able to click each of the layout's buttons and those the Switch can see but when I hit the buttons on the joypad both host and client side nothing happens.
Is there something I'm missing to this setup? I've updated both Gtuner and the Titan One firmware. I wondered if it was the Ximput drivers but I can use any controller just fine in Steam and emulators that use it.
-Raven
In "Direct Input" it sees the Ximput with the plugged in controller.
I opened MaxAim DI and I'm able to click each of the layout's buttons and those the Switch can see but when I hit the buttons on the joypad both host and client side nothing happens.
Is there something I'm missing to this setup? I've updated both Gtuner and the Titan One firmware. I wondered if it was the Ximput drivers but I can use any controller just fine in Steam and emulators that use it.
-Raven
-
Raven - Private
- Posts: 1
- Joined: Thu Mar 25, 2021 5:14 am
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 90 guests