My first time using the Titan One
3 posts
• Page 1 of 1
My first time using the Titan One
Ok so it just came in the mail! I have updated the firmware and loaded this gamepack in bank 1 http://www.consoletuner.com/kbase/black_ops_3.htm. My XB1 controller authenticates and I push the button until its on 1.
But the instructions are vague for using the gamepack with the XB1 controller. It mentions lights on the DS4 and Xbox360. But how do I scroll through or know where I'm at with the XB1 controller? Because I definitely do not have rapid fire when I go into the game.
But the instructions are vague for using the gamepack with the XB1 controller. It mentions lights on the DS4 and Xbox360. But how do I scroll through or know where I'm at with the XB1 controller? Because I definitely do not have rapid fire when I go into the game.
-
madjack - Sergeant
- Posts: 9
- Joined: Fri Jan 08, 2016 9:37 pm
Re: My first time using the Titan One
Scratch that! I plugged it back into my PC and found a setting to "enable rapid fire" I then re wrote it and now have rapid fire.
-
madjack - Sergeant
- Posts: 9
- Joined: Fri Jan 08, 2016 9:37 pm
Re: My first time using the Titan One
The easiest way to configure the gamepack is using Gtuner. You need to ensure that you configure the gamepack with the Gtuner gamepack configurator and ensure the configuration is loaded as part of the programming.
Here is a beginner's guide.
http://www.consoletuner.com/forum/viewtopic.php?f=18&t=1789
Here is a beginner's guide.
http://www.consoletuner.com/forum/viewtopic.php?f=18&t=1789
-
UK_Wildcats - Brigadier General
- Posts: 2243
- Joined: Thu Jan 08, 2015 6:53 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 120 guests