Macro Loop Delay
5 posts
• Page 1 of 1
Macro Loop Delay
I am posting this here instead of the titan two forum because the titan two appears to be working. I have created a macro and have a script to loop it however there is a long delay between the end of the macro and the start of it again. how can I adjust this ?
*edit here is the script im using
main {
if(get_val(BUTTON_12)) { // Loop the Macro until the button is released.
macro_run("MVMT.gmk");
} else macro_stop();
}
*edit here is the script im using
main {
if(get_val(BUTTON_12)) { // Loop the Macro until the button is released.
macro_run("MVMT.gmk");
} else macro_stop();
}
-
Forevka - Corporal
- Posts: 5
- Joined: Tue Mar 10, 2020 11:23 pm
Re: Macro Loop Delay
Check/edit your macro, you may have some idle time at the start or end of it.
-
Scachi - Brigadier General
- Posts: 3044
- Joined: Wed May 11, 2016 6:25 am
- Location: Germany
Re: Macro Loop Delay
I've selected everything im not using and used the erase/remove selection from the toolbar. this is what it looks like https://imgur.com/a/YQux7NB
-
Forevka - Corporal
- Posts: 5
- Joined: Tue Mar 10, 2020 11:23 pm
Re: Macro Loop Delay
Upload your .gmk file for us to check it.
-
Scachi - Brigadier General
- Posts: 3044
- Joined: Wed May 11, 2016 6:25 am
- Location: Germany
Re: Macro Loop Delay
Forevka wrote:there is a long delay between the end of the macro and the start of it again. how can I adjust this ?
How long is this delay? few milli-seconds or longer (liker 100ms)?
ConsoleTuner Support Team
-
J2Kbr - General of the Army
- Posts: 20323
- Joined: Tue Mar 18, 2014 1:39 pm
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 100 guests