Site Tools
Sidebar
User's Manual
t2:usage_guides:controllers:playstation4
Table of Contents
PlayStation 4 Controllers
PlayStation 4 official and third-party controllers are supported by the Titan Two and can be used to play on all compatible gaming systems.
Controller Protocol
Relevant information about the PlayStation 4 controller protocol.
USB Polling Interval | 4ms |
Bluetooth Polling Interval | 1.25ms |
Device Authentication | YES full-time |
Specific Features
Titan Two support for PlayStation 4 specific features.
Touchpad | YES |
Lightbar | YES |
Rumble (Vibration) | YES |
Motion Sensors | YES |
Speaker | YES DualShock 4 V2 required |
Headset | YES DualShock 4 V2 required |
Wired Connection (USB)
Requirements
- Micro-USB cable.
Regular Usage
- Connect the Micro-USB cable to the Titan Two USB port labeled
INPUT-A
orINPUT-B
; - Connect the other end of the Micro-USB cable on the PlayStation 4 controller.
Wireless (Bluetooth)
Requirements
First-time Configuration
Pairing Method A:
- Connect the controller on the Titan Two as described in the Wired Connection (USB) section;
- Wait until the LED of the USB port turns green, the controller is now paired with the Titan Two;
- Unplug the Micro-USB cable.
Pairing Method B:
- Press and hold the right side
ARROW
button on the Titan Two for 2.5 seconds to enter in pairing mode; - Within 20 seconds, press and hold the
SHARE
andPS
buttons on the controller; - The controller light-bar will start flashing white and after few seconds it should be paired with the Titan Two.
Pairing Method C:
- Connect the Titan Two
PROG
port to the computer using the provided Micro-USB cable; - Open Gtuner IV, go to the Device Configuration pane and click the
Wireless Bluetooth Pairing
button; - Within 20 seconds, press and hold the
SHARE
andPS
buttons on the controller; - The controller light-bar will start flashing white and after few seconds it should be paired with the Titan Two.
Regular Usage
- Press the
PS
button on the controller to start wireless connection with the Titan Two.
Wireless (Adapter)
Requirements
- DualShock 4 USB Wireless Adaptor 3).
First-time Configuration
- Connect the DualShock 4 USB Wireless Adaptor to the Titan Two USB port labeled
INPUT-A
orINPUT-B
; - Press the DualShock 4 Wireless Adaptor until the blue light starts flashing;
- Press and hold the
SHARE
andPS
buttons on the controller; - The controller light-bar will start flashing white and after few seconds it should be paired with the DualShock 4 USB Wireless Adaptor.
Regular Usage
- Connect the DualShock 4 USB Wireless Adaptor to the Titan Two USB port labelled
INPUT-A
orINPUT-B
; - Press the
PS
button on the controller to start wireless connection.
IMPORTANT NOTE: DualShock 4 controllers connected over the USB Wireless Adaptor cannot be used as the authentication controller for PlayStation 4, and will require another official DualShock 4 controller plugged directly into the Titan Two. |
t2/usage_guides/controllers/playstation4.txt · Last modified: 2020/08/03 00:48 by sNAP