PlayStation 5 official and third-party controllers are supported by the Titan Two and can be used to play on all compatible gaming systems.

Authentication with the DualSense and PS5 is not currently supported.

These are the options available until a better solution is released in 2022:

• Third Party PS4 Controller - Some games allow third party PS4 controllers and can be used for authentication.

• PS4 Version - You can use the PS4 version of the game if available with a DualShock or third party PS4 controller.

• Remote Play - The current preferred method is remote play. Click here for remote play instructions.

Relevant information about the Xbox Series X|S controller protocol.

1. Micro-USB cable.

1. Connect the Micro-USB cable to the Titan Two USB port labeled INPUT-A or INPUT-B;
2. Connect the other end of the Micro-USB cable on the PlayStation 4 controller.

1. Bluetooth Module ¹⁾;
2. Micro-SD Card ²⁾;
3. Optional: Micro-USB cable for the first-time configuration pairing method A and C.

1. Install and configure the Bluetooth Module and the Micro-SD Card on the Titan Two.

Pairing Method A:

1. Connect the controller on the Titan Two as described in the Wired Connection (USB) section;
2. Wait until the LED of the USB port turns green, the controller is now paired with the Titan Two;
3. Unplug the Micro-USB cable.

Pairing Method B:

1. Press and hold the right side ARROW button on the Titan Two for 2.5 seconds to enter in pairing mode;
2. Within 20 seconds, press and hold the SHARE and PS buttons on the controller;
3. The controller light-bar will start flashing white and after few seconds it should be paired with the Titan Two.

Pairing Method C:

1. Connect the Titan Two PROG port to the computer using the provided Micro-USB cable;
2. Open Gtuner IV, go to the Device Configuration pane and click the Wireless Bluetooth Pairing button;
3. Within 20 seconds, press and hold the SHARE and PS buttons on the controller;
4. The controller light-bar will start flashing white and after few seconds it should be paired with the Titan Two.

1. Press the PS button on the controller to start wireless connection with the Titan Two.