Site Tools
Sidebar
User's Manual
t2:usage_guides:controllers:xboxone
This is an old revision of the document!
Table of Contents
Xbox One Controllers
Xbox One official and third-party controllers are supported by the Titan Two and can be used to play on all compatible gaming systems.
Controller Protocol
Relevant information about the Xbox One controller protocol.
USB Polling Interval | 8ms |
Device Authentication | YES enumeration |
Specific Features
Titan Two support for Xbox One specific features.
Rumble (Vibration) | YES |
Impulse Triggers | YES |
Chatpad | YES Xbox One compatible controller required |
Headset | YES Xbox One compatible controller required |
Wired Connection (USB)
Requirements
- Micro-USB cable.
Regular Usage
- Connect the Micro-USB cable to the Titan Two USB port labeled
INPUT-A
orINPUT-B
; - Connect the other end of the Micro-USB cable on the Xbox One controller.
Wireless (Adapter)
Requirements
First-time Configuration
- Install the Micro-SD Card on the Titan Two;
- Connect the Titan Two
PROG
port to the computer using the provided Micro-USB cable; - Open Gtuner IV, go to the Device Configuration pane and click the
Configure
button;
Pairing:
- Connect the Xbox Wireless Adapter to the Titan Two USB port labeled
INPUT-A
orINPUT-B
; - Wait for the status LED of the USB port to turn green, indicating the Xbox Wireless Adapter was successfully initialized;
- Press the sync button on the Xbox Wireless Adapter until the white LED starts flashing;
- Press and hold the sync button on the Xbox One controller;
- The Xbox button will start flashing white and after few seconds it should be paired with the Xbox Wireless Adapter.
Regular Usage
- Connect the Xbox Wireless Adapter to the Titan Two USB port labeled
INPUT-A
orINPUT-B
; - Wait for the status LED of the USB port to turn green, indicating the Xbox Wireless Adapter was successfully initialized;
- Press the
Xbox
button on the controller to start wireless connection.
Wireless (Bluetooth)
Requirements
- Bluetooth Module 3);
- Micro-SD Card 4);
- Xbox One controller equipped with Bluetooth;
- Optional: Micro-USB cable for the first-time configuration pairing method B.
On Bluetooth-supported controllers, the plastic around the Xbox button is part of the face of the controller. On controllers without Bluetooth, the plastic around the Xbox button is part of the top, where the bumpers are. |
First-time Configuration
Pairing Method A:
- Press and hold the
UP
button on the Titan Two for 2.5 seconds to enter in pairing mode; - Within 20 seconds, press and hold the sync button on the controller;
- The Xbox button will start flashing white and after few seconds it should be paired with the Titan Two.
Pairing Method B:
- Connect the Titan Two
PROG
port to the computer using the provided Micro-USB cable; - Open Gtuner IV, go to the Device Configuration pane and click the
Pair Controller Wirelessly
button; - Within 20 seconds, press and hold the sync button on the controller;
- The Xbox button will start flashing white and after few seconds it should be paired with the Titan Two.
Regular Usage
- Press the
Xbox
button on the controller to start wireless connection with the Titan Two.
IMPORTANT NOTE: Authentication with the Xbox One consoles does not works over Bluetooth connection. |
t2/usage_guides/controllers/xboxone.1523912395.txt.gz · Last modified: 2018/04/16 16:59 by J2Kbr