ConsoleTuner

I am using xbox elite controller with ximapex at 500hz. which input polling rate I should set? currently I set both input and putput at 500hz. does the 500hz polling rate work for xbox elite controller? thank you

Thank you Scachi for your feedback.

Scachi wrote:Does the Input Polling Rate settings apply (and has an effect) to all types of connections (usb/bluetooth/Input-A,Input-B, OTG) or only for specific ones ?

The input polling rate is applied to all USB inputs, including to the PROG and OUTPUT ports with OTG adapter. The Bluetooth inputs are not affect by this setting. The Bluetooth architecture is different from USB, it does not requires the host to poll the device, is the device that determines how often a data packet is send.

stbobo wrote:I am using xbox elite controller with ximapex at 500hz. which input polling rate I should set? currently I set both input and putput at 500hz. does the 500hz polling rate work for xbox elite controller? thank you

The Xbox One controller responds only at 250 Hz, not mattering how fast it is polled. You can, however, have the Titan Two configured to poll at 1000Hz without any detrimental effect.

Did anyone of you downgrade to stable again successfully ?
I changed the gtuner.cfg entry to beta_tester=false , restarted gtuner, put my T2 into P mode and it said it is installing the stable version 1.4.3.1. It finishes fine. When the T2 connects again GTuner is still saying FW 1.5.1.2
Restarting gtuner or the T2 doesn't change it. It is still reporting the beta FW.
I tried with both of my T2 but can't downgrade one.

It worked for me by forcing P mode to update

prototype wrote:It worked for me by forcing P mode to update

Thank you for the reply
I'll try again tomorrow and from another computer.

Do you know if you did update the upated beta FW 1.5.1.2 ? viewtopic.php?f=2&t=13510&start=30#p89297
Or were you still running the FW from the initial post 1.5.1.0 ?

Just to rule out that my issue happens only when downgrade from the 1.5.1.2

Yes i did the update 1.5.1.2 before the rollback but not with my second device which is still in 1.4.3.0.

Has anyone had success getting the C40 to work with the T2 on the beta firmware?

When beta_tester=true will Gtuner still update to future stable releases or will it only update to Beta versions? just wondering if I can leave the value as true if I like the results of this beta.

kryptik66 wrote:When beta_tester=true will Gtuner still update to future stable releases or will it only update to Beta versions? just wondering if I can leave the value as true if I like the results of this beta.

Same here ... wondering the same.