Quick Question?

[battlelog]

So I was wondering about the "Input & Output polling rates" So I play alot on my PC using the DS4, I have to use the USB Xbox 360 protocol in order to play with my DS4.

Well I was wondering would'nt that cause lag because as we know the Xbox controllers have more input lag than the DS4 controller??

Reason I am asking this question is because I notice when I play on my bf4 on my pc, I notice a bit of controller lag, and no its not my pc or monitor. I have the polling rates on the T2 set to 1000Hz.

So setting up my ds4 as a xbox controller on my pc, would that cause any issues??

Also anybody else use the t2 to play on pc?

Thanks in advance.

[DontAtMe]

Should not matter that your using the Xbox Protocol. As long the Output Polling is set to 1000hz then you will benefit with the DS4 lower latency.

[battlelog]

Thank you for the reply man.

[bonefisher]

Doesn't matter even if polling rate is different because the game doesn't receive a press until 30ms each of the controllers! Usually pass the 30ms mark so polling rate is 4ms for PS4 controller so 8*4=32ms or Xbox controllers 8ms polling rate which still gets a 8*4=32ms so they are there at the same time..... never thought of that have ya!

[bonefisher]

Even with the 60fps you would get 8*2=16ms Xbox controller and 4*4=16ms PS4 controller! Been testing but still doesn't receive a press this quick anyway....still is pass the 30ms mark!

[battlelog]

Thank for the great answer bone.