Wireless Support for Xbox One Controllers

[juroz]

i have the first version of the titan two, the Xbox One X controller, official cables and the newest XBOX Wireless adapter.

I can autheticate but i have know controll of my Xbox. I also dont get the collor orance for a few second but green right a way.

What can i do or try?

[J2Kbr]

As first troubleshooting procedure, please try the following:

- remove all controllers/adapter from the Titan Two and connect it to your computer via PROG port;
- open Gtuner IV and go to Device Configuration panel;
- Click on the button "Format FAT 32" and wait this operation finish;
- Click on the button "Configure" and wait the files be copied to the sd card;

Now plug the Xbox Wireless Adapter on Input-A.

The status LED should first turns orange and after few seconds green.

[juroz]

I did that but it turns green right a way.

[J2Kbr]

I did that but it turns green right a way.

that is unexpected. Please check this.

with the Titan Two connected to the computer via PROG port, open Gtuner IV and to Device Monitor.

now plug the Xbox Wireless Adapter to Input A.

in the central area there are the status of all available port of the Titan Two, please let me know what shows in the USB-A filed.

Thank you.

[juroz]

Xbox One Wireless [IN}.

[J2Kbr]

Xbox One Wireless [IN}.

This is the expected result on Gtuner IV. Perhaps the orange color is blinking fast and you didn't notice it.

In the Gtuner's output panel, do you get any error message related with the Xbox Wireless adapter after plugging it on the Titan Two?

[juroz]

No i have no error messages. None of my controllers work. I have a elite, Xbox S and a Xbox X controller. I also just reset the firmware and updated again but none works:-S.

[Mad]

Try clearing the xbox cache with a hard reset - with the console turned on hold down the power button for 20~ seconds until it shuts off.

Alternatively you can unplug the power cord from the xbox and wait 20~ seconds before plugging back in.

If possible can you plug the wireless adapter directly into a PC and see if works as expected?

[juroz]

i have already done that but it doesn't work. The controller will pair with the wireless adapter when in a computer but not when it is in the Titan two. Also it wont pair to the titan two directly.

When i can take a wild guess it looks like the bluetooth software or hardware in the titan two is not working correctly.

I also never seen a orange light blinking. Even not when i updated the firmware and formatted the SD card and installed it again.

[juroz]

Yes i updated to the new released firmware and it finaly fixed my problem. I'm so happy!!!

Thanks for trying to help