ConsoleTuner

Hey!

Is there a Hotkey to Enable Capture Mode?
I use a Capture Card and Parsec for a Low Latency Alternative to Remote Play.
But i have to Fullscreen the Capture Card Software befor activating Capturemode. So a Hotkey is needed.

Currently a hot-key for the Capture button is not implemented. This implementation would be easy, but not sure if it will work as you expects. For the hotkey to work the MaxAim window should be the active window, and based on what you described the active window would be the capture card software.

The only solution here I can think is using a multi-monitor setup, where in one you have the capture card software in full screen and on the other the MaxAim DI.

Multi Monitor is not Possible. Parsec does not support it.

HI Is there a Hotkey knowledge of dianabol to Enable Capture Mode? I use a Capture Card and Parsec for a Low Latency Alternative to Remote Play.But i have to Fullscreen the Capture Card Software befor activating Capturemode. So a Hotkey is needed.

Currently there is no shortcut key to enter in capture mode, I added your request in the MaxAim to-do list to be implemented on the next plugin release. Thank you.