PS4 Authentication

[JMPS488]

If i plug titan one in ps4 and computer is there a way to stop authentication ?

[J2Kbr]

If i plug titan one in ps4 and computer is there a way to stop authentication ?

Not sure if I fully understood your question. But you can use the MaxAim DI to crossover play on PS4 without interruptions dues the authentication. The MaxAim DI captures the inputs from the controller connected on PC, converts these inputs according to layout you made and, through the Titan One device, it sends your commands to console.

For example, the connections required to use on PS4:

(1) Titan One on PS4
(2) Titan One on PC (mini-USB cable)
(3) PS4 controller on Titan One
(4) Your controller controller on PC

[JMPS488]

I am using gamerec, My titano one is connected to ps4, ds4 and pc all with cable. I was wondering if i still get authentications in that situation.

[J2Kbr]

If you have the PS4 controller directly connected on the Titan One, should not happen any authentication interruption.

[mjfame]

If i plug titan one in ps4 and computer is there a way to stop authentication ?

To be certain:


Connect the T1 to your PC > Start Gtuner Pro >
> Open the OPTIONS menu and navigate to TITAN ONE tab and locate the option that reads,
"Enable PS4 partial crossover support (auto reconnect every 10 min)" then make certain that the box to the left is unchecked (disabled). I had experienced random disconnects due to the fact that I had forgotten to disable that option before using the T1 with MaxAim.

Also, make certain that you aren't running a script with any sort of "Auto-re-auth" instructions.


Hope this helps.

-Jim