Headset Sound Stopped after Latest Firmware Update
3 posts
• Page 1 of 1
Headset Sound Stopped after Latest Firmware Update
Hi all,
Just a heads-up - the sound stopped after the last firmware update.
2019-03-16, Ver 1.00RC-5
I'm using the T2 in full passthru mode.
T2 connected to PS4, wired cables to controller and wired headset to controller.
- the controller sometimes also gets disconnected after i plug the headset
Just a heads-up - the sound stopped after the last firmware update.
2019-03-16, Ver 1.00RC-5
I'm using the T2 in full passthru mode.
T2 connected to PS4, wired cables to controller and wired headset to controller.
- the controller sometimes also gets disconnected after i plug the headset
- My recommendation for learning C programming: 'C Programming Absolute Beginner's Guide'
- Create your own scripts with GPC2 Scripting
- Create your own scripts with GPC2 Scripting
-
jelly44 - Sergeant Major of the Army
- Posts: 220
- Joined: Tue Feb 05, 2019 3:49 pm
Re: Headset Sound Stopped after Latest Firmware Update
As explained here: viewtopic.php?p=81657#p81657
With firmware update 1.00RC-6 (just released), the access timing also was adjusted for the USB controller registers, fixing the described issue. Thank you for reporting.
In the version 0.98B-80 (2019-03-05) the firmware compiling optimization was changed from -Os (optimized for size) to -O2 (optimized for speed). Yesterday, after some debugging, was verified the main processor was accessing the data bus with the USB controller too fast (due the optimization change) which can potentially cause corruption on the data transfer. The data bus access timing were adjusted on the firmware released yesterday.
With firmware update 1.00RC-6 (just released), the access timing also was adjusted for the USB controller registers, fixing the described issue. Thank you for reporting.
ConsoleTuner Support Team
-
J2Kbr - General of the Army
- Posts: 20323
- Joined: Tue Mar 18, 2014 1:39 pm
Re: Headset Sound Stopped after Latest Firmware Update
J2Kbr wrote:As explained here: viewtopic.php?p=81657#p81657In the version 0.98B-80 (2019-03-05) the firmware compiling optimization was changed from -Os (optimized for size) to -O2 (optimized for speed). Yesterday, after some debugging, was verified the main processor was accessing the data bus with the USB controller too fast (due the optimization change) which can potentially cause corruption on the data transfer. The data bus access timing were adjusted on the firmware released yesterday.
With firmware update 1.00RC-6 (just released), the access timing also was adjusted for the USB controller registers, fixing the described issue. Thank you for reporting.
- My recommendation for learning C programming: 'C Programming Absolute Beginner's Guide'
- Create your own scripts with GPC2 Scripting
- Create your own scripts with GPC2 Scripting
-
jelly44 - Sergeant Major of the Army
- Posts: 220
- Joined: Tue Feb 05, 2019 3:49 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 107 guests